BLUE PLUS 100 LCD

Anuncio
BLUE PLUS 100 LCD
MUY ALTA EFICIENCIA, MÍNIMO ESPACIO, ECONÓMICO Y POTENTE
ÚLTIMA TECNOLOGÍA EN TRANSMISORES DE FM
CARACTERÍSTICAS PRINCIPALES DEL EXCITADOR BLUE PLUS 100 LCD:














PANTALLA TÁCTIL A COLOR LCD PARA UNA FÁCIL DEFINICIÓN DE PARÁMETROS DE AJUSTE
Y LECTURA
EXTREMADAMENTE BAJA DISTORSIÓN: THD, IMD Y TIM
ESTÉREO DE MUY ALTAS CARACTERÍSTICAS: SEPARACIÓN TIP. 60 DB
ENTRADAS L /R, RDS/SCA, AUX, MPX, AES-EBU (XLR Y ÓPTICA), AUDIO IP
SEIS MEMORIAS DE PARÁMETROS DISPONIBLES (FRECUENCIA, SENSIBILIDAD, POTENCIA,
ETC.) QUE PERMITEN ALMACENAR CONFIGURACIONES DIFERENTES
LISTO PARA SISTEMAS N + 1
COMPLETAMENTE DE BANDA ANCHA
CONTROL REMOTO PARA SUPERVISIÓN Y TELEGESTIÓN VÍA LAN, RS485
AMPLIFICADORES DE RF UTILIZANDO LA ÚLTIMA GENERACIÓN DE SEMICONDUCTORES DE
POTENCIA DE RF LDMOS
CONTROL DE POTENCIA AUTOMÁTICO (APC) PERMITE MANTENER ESTABLE LA POTENCIA DE
RF PRESELECCIONADA HASTA ROE 1,5: 1. MAYOR VALOR ROE PROVOCA REDUCCIÓN DE
POTENCIA
POTENCIA DE SALIDA NOMINAL RF 100 W. AJUSTABLE DESDE 0 HASTA 100 W
INCLUYE FILTRO DE ARMÓNICOS RF Y MEDIDOR DE POTENCIA
ALTA PUREZA ESPECTRAL
CUMPLE CON NORMATIVAS CCIR Y FCC
BLUE PLUS 100 LCD
GENERAL
AES/EBU OPERATION (optional Analog)
Power Output: 100W adjustable from front panel.
RF Output Impedance: 50 ohm.
RF Output Connector: “N” type.
Monitor RF: BNC connector.
VSWR: 10:1
Frequency Range: 87.5 ÷ 108.00 MHz.
Programmable in 10 kHz steps.
Frequency Stability: ±1 ppm from -5 to 45°C.
External Reference: 10 MHz BNC connector back panel.
Type of Modulation: analog synthesis.
Off Lock Attenuation: ≥ -80 dBc.
Modulation Capability: ±150 KHz.
Limiter built in
Power Good Detector: adjustable from20÷90% of the power.
Audio Presence Detector: adjustable time from front panel.
External AGC: Automatic, with fine ADJ from front panel.
Modulation Mode: Mono, Stereo, Multiplex, SCA, RDS, Aux.
Preemphasis: Flat/50/75µs selectable from front panel.
Asynchronous AM S/N Ratio: -70 dB.
Synchronous AM S/N Ratio: -65 dB .
RF Harmonics: Exceeds EBU/CCIR/FCC requirements.
RF Spurious: Exceeds EBU/CCIR/FCC requirements.
Input Connector: XLR female, optical TOS-LINK.
Data Format: S/PDF,AES/EBU, IEC958, EIAJCP340/1201.
D/A Converter: 24 bit.
Sampling Frequency: from 32 to 96 KHz.
MONAURAL OPERATION
Audio Input Impedance: 600 ohm - ≥10 Kohm balanced.
Audio Input Level: -6 to +12 dBm
Input Connector: XLR female.
Audio Frequency Response: ±0.1 dB, 30 Hz to 15 KHz.
Total Harmonic Distortion + Noise: 0.01% @ 400 Hz.
Intermodulation Distortion: 0.01%, 1 KHz/1.3 KHz, 1:1 ratio.
Transient Intermodulation Distortion: 0.01% 2.96KHz square wave and 14
KHz sine wave.
Distortion: 0.01% 2.96KHz square wave and 14 KHz sine wave.
FM S/N Ratio: -85 dB rms detector,-80 dB below ±75 KHz deviation.
STEREO OPERATION
Audio Input Impedance: 600 ohm - ≥10 Kohm balanced.
Audio Input Level: 6 to +12 dBm
Input Connector: XLR female.
Audio Frequency Response: ±0.1 dB, 30 Hz to 15 KHz.
Total HarmonicDistortion + Noise: 0.01% @ 400 Hz.
Intermodulation Distortion: 0.01%, 1 KHz/1.3 KHz, 1:1 ratio.
Transient Intermodulation Distortion: 0,01% 2.96KHz square wave and 14
KHz sine wave.
FM S/N Ratio: -85 dB rms detector, -80 dB below ±75 KHz deviation.
Stereo Separation: -45 dB@30Hz ≥ -60dB@ Freq ≥ 100 Hz
Crosstalk attenuation: ≥ 45 dB@15kHz.
38 KHz Suppression: ≥ -85 dB.
Pilot Frequency: 19 KHz ± 1 Hz
Output Pilot: 2Vpp adjustable from front panel.
AUDIO IP (optional)
Lan: Audio IP and Web interface to control and configure
Transport protocol: RTP over UDP;
Protocols: RFE Codec: Alaw,OGG VORBIS, MP3, AAC
SHOUTCAST/ICECAST Codec : TX MP3, RX AAC, AAC+, MP3, OGG(icecast 2.x)
SCA, RDS, AUX OPERATION
Input Impedance: ≥ 2 Kohm.
Input Level: -6 to +12 dBm.
Frequency Response: ±0.1 dB, 50 KHz to 100 KHz.
Input Connector: BNC female.
AUXILIARY CONNECTIONS
RS485: DB9 connector back panel.
CAN BUS (optional): DB9 connector back panel.
Telemetry Interface: connector DB25 back panel.
LAN: RJ45 connector back panel
MPX OUT: connector BNC back panel.
OPTIONS
RDS/RBDS Programmable Coder via PC.
OIRT or JPN version.
SNMP
Audio Over IP
AES/EBU (only analog)
ELECTRICAL
AC Input Power: 90÷260 VAC 50/60 HZ single phase.
AC Apparent Power Consumption: 100VA @ 50W,
Cos Ф> 0.98.
Cooling: Forced air.
Acoustic noise:< -56 dBa @ 1 meter.
ENVIRONMENTAL
Operating temperature: -10°C to +50°C.
Max Operating Altitude: 2000 mt.
Relative Humidity Range: 0 to 90%.
PHYSICAL DIMENSION
Mounting: Standard 19” chassis 2 U rack.
Size: W x 483 mm. D x 470 mm. H x 88 mm.
Weight: ~ 6,0 Kg. (50-100w), 15Kg. (500-1000W)
Software update
Core micro : Via Web
MULTIPLEX OPERATION
Composite Input Impedance: 2 Kohm unbalanced.
Composite Input Level: -6 to +18 dBm
Input Connector: BNC female.
Composite Amplitude Response: ±0.1 dB, 30 Hz to 100 KHz.
Total Harmonic Distortion + Noise: 0.01% @ 400 Hz.
Intermodulation Distortion: 0.01%, 1 KHz/1.3 KHz, 1:1 ratio.
Transient Intermodulation Distortion: 0.01% 2.96KHz square wave and 14
KHz sine wave.
FM S/N Ratio: -85 dB rms detector, -80 dB below ±75 KHz deviation
Descargar