SS Decal Variations, an Informational Compendium. This section presents an overview of mainstream decals used by the SS from 1933-1945. If you are familiar with or own my books, you will see these same decals laid out in detail as to origin, correlation to helmet manufacturer, and approximate time period used. During my 51 years of collecting German helmets, I have identified several decal variations, and note that among the nearly dozen possible, there were five basic types that were manufactured and used within the mainstream production of SS helmets. These are: 1) CA Pocher, Nuremberg, 2) FW Quist Pattern, 3) NS or “Champagne Rune,” 4) EF Pattern and 5) ET Pattern. Each of these decals except Pocher had internal variations, albeit slight. Review these often for reference when comparing helmets you are considering buying ‘out there’ in order to avoid getting stung. I hope you download this document for your use and sharing. My intellectual property has already been ‘shared’ unofficially on forums and other means for over 12 years since my SS-Steel books came out, so feel free to continue doing so with this brief, but structured document. For any questions, I am available anytime at kellyhicks@hotmail.com I. Early SS Decal Variations (see “SS-Steel” vol. 1 and 2 for details) The SS used several variations of helmet insignia until they settled on their main production styles. Some of these included the SS-VT circular runes and mobile swastika, the scalloped LAH decals, the “Fat Runes” decal, the “Austrian Pattern runes” decal and the “Round Bottom” runic shield. i) SS-VT helmet insignia. Here is an original hand- rendered set of SS-VT insignia, on a helmet found in a Minnesota barn in September 2015. ii) “Fat Runes” decal from an ET M35 Helmet. There is no corresponding party shield; ET and Pocher styles were both used with this shield. Fat Runes are a ‘face-up’ decal. iii) Austrian Pattern SS Decals, found on special “Earth Brown” transitionals and at least one Sicherheitsdienst M34 helmet. iv) Round Bottom Runic and Party shields, found on SD-Related RZM and M34 helmets. This rare variant appears to be ‘face down’ decals, lacking the celluloid film. II. “Mainstream” Production Decals used by the SS between 1935-1945. 1) CA Pocher—design approved by Reichsfűhrer-SS in July-August 1934. Worn by the SS on a large variety of helmets throughout the entire period up until 1945. CA Pochers are ‘face-up’ water slide type decals. 2) FW Quist Pattern (Narrow Q). Believed designed and authorized by early 1938. Used on Q helmets exclusively through end of production in 1943, through to the end in 1945. Quist decals appear to be ‘face down’ decals, lacking presence of celluloid film. Lack of examples of this rune still on the paper noted. FW Quist Wide Pattern Rune. See SS-Steel Expanded Edition for detailed reference. 3) NS Pattern or “Champagne Rune”. These appear in a wide and a narrow variation, in very small number on a variety of M35, 40 and 42 helmets. These insignia are less understood and not universally accepted as original Third Reich, due to the amount of fakes that exist. Speaking about the original examples I have handled, here is my analysis from since my first encounter with this decal in the 1970s; and excerpts from my 2010 publication of the updated edition of “SSSteel.” Below is a wide style champagne rune decal on an NS M35 Helmet, and a narrow style on an NS M40. The decal on the left has the celluloid carrier film visible (face up); the narrow pattern does not (face down). Lack of unapplied decals (still on paper) noted. *See Footnote at the end for more information on Champagne Runes 4) EF Pattern Runes. These appear to have been designed and approved sometime around 1941, and with two known m-40 exceptions, appear on the EF M42 helmet almost exclusively. Here are examples of the EF rune and party shields. EF Pattern runic and party shields. These party shields are distinct from stock party shields found on other SS helmets and are found universally on EF M42 Polizei helmets. The runic shields appear to be ‘face-down’ decals. Lack of examples of these decals still on the paper noted. 5). ET Pattern Decals. These are probably the most abundant version of original SS decals encountered. They began to appear universally on ET-produced helmets in 1938; and then on M40 and M42 helmets through until the end of 1943 from ET. The runic shield on the M35s is different from that of the M40 / 42 and are pictured below for reference. Top left: ET Runes on an M35; right ET party shield on M35. Right: ET runes on M40. The M35 pattern are ‘faceup’ decals. The M40 pattern may be face down. ################################################################# Footnote: *My viewpoint on Champagne Rune Decals. Based on having seen these decals since the 1970s, my viewpoint has always been that they are real. They were not plentiful, but they appeared occasionally over the years, on M35, M40 and M42 shells. Back in those days, our analysis was very thin, consisting mainly of ‘first’ and ‘second’ pattern decals, but frankly not even that sophisticated. I did not even differentiate them visually back at that time, because I saw so few SS helmets available anyway (this was based on my observations starting 40-50 years ago). In subsequent years, as I encountered them ‘in the field’, I considered recognized them as part of the SS decal pantheon. Friends of mine over the years sometimes expressed doubt in their originality, so in my early SS books—while I picture them—I do not specifically say they are different, even though by 1993 I definitely had noticed they were made differently. And of course there are fake ones, just as there are fake Qs, ETs and Pochers. Many fake champagne runes, (two of which I’ve had in my hands) were said to have been done by an American and sold on ebay. Evidence supporting my viewpoint on Champagne Runes: As I show in SS-Steel, I vet purchased two of them in the early-mid 1970s. In my first book, SS Helmets, published in 1993, I show one or two M35s with champagne runes. One is an NS and one is an ET. There are color closeups of the decals, which show the celluloid underlay and other characteristics of ‘mainstream’ decals of a more conventional manufacture technique. So from the early-mid 70s to 1993, I had collected a total of 4 champagne rune bearing SS helmets, along with probably thirty five Q, and ET helmets. I did not even see my first EF pattern decal helmet until 1994, and while I thought it was inherently real, I had no point of reference on it. This was how asunder the analytical body of evidence on helmets was back then. With the internet the way it is today, you can learn 20 years’ worth of hard earned knowledge in about six months. (You can also un-learn a lot with the equally fast pace of mis-information nowadays.) There is no substitute for experience. Long after I had come up with my catalogue of SS decals and their correlation to helmet makers, which I did in the latter 1990s, I published the first edition of SS Steel to advance my theory on ‘NS pattern’ decals. I actually got the idea for the term ‘Champagne Runes’ decals from my mentor, Al Barrows, who in more than one conversation shared with me that he also thought there was a subdued version of the SS decal, which had a champagne like look to it. I first featured champagne runes as a decal variation in my first volume of SS-Steel in 2003. As I was preparing to publish SS Steel “Expanded Edition” in 2008-09, I had begun more earnestly cataloging and studying champagne runes. Collectors had been sending me their champagne rune helmets for my analysis. I noted that some had appeared from such remote corners of the earth, yet bore characteristics of already known examples, so I realized my hypothesis was bearing out in the physical evidence. In 2010, I encountered XRay Florescence technology, which I embraced as a potentially valuable authentication tool based on the purity of the technology. I participated in the creation of a large database of scans of all the SS helmets’ decals I could get my hands on, approximately 200 examples over a several month period. When we had more than three hundred examples in the database, we developed a mean, a ‘signature’ of the key elements that each decal was made of. This included champagne runes, which bear nearly the identical signature as a CA Pocher, with the exception of the presence of about 3% copper. I was astounded; this was to me the element that possibly accounts for the bronze color of this type of decal. The way it basically works is the surface of the object, in this case decals, is bombarded with xray energy from a hand-held device. The device reads the molecular, non-organic (metals basically) materials that make up the decal. These can be distinguished from the underlying helmet metal and also from the paint. The amount of certain elements in the decals is pretty consistent within a very, very small margin of error. In the case of decals produced in old fashioned printing methods in the 1930s and 1940s, a very different array of elements is presented than modern plastic and silicate fakes. Very different. Not only that, each maker’s SS decal from the period only varies from the others by a fraction. Such was the case with champagne runes, which basically show the same characteristics as a Pocher or a Quist, with the exception of added copper. The data are difficult to present in a simple way, but when I have the data charts in a way that conveys the information clearly, I will update them into this pdf so readers can see the numbers. What collectors further need to understand is that XRay Florescence technology is a widely used methodology for determining the age and authenticity of an inorganic object based on its composition. It is not a guess, and not a “what if”; it is an empirical scientific methodology. Chemical engineers seem to have no problem understanding this, but collectors not close to it can be told it is wrong or does not work, and therefore their understanding of it falls down. It is fact based and objective, and available to all. The damage done to the technology some helmet discussion forums, by saying it was flawed, was immeasurable; a boon to fakers who now have a clearer path to deceive collectors with even more advanced renditions of their fakes—of all kinds (remember, there are fake pochers, quist, ef Austrian, etc; all decals are faked profusely). Here are links that the reader can follow to see what XRF technology is and how it is presently used by the top forensic and research specialists in the world. This is a useful tool in many applications, in standard use in museums and other venues throughout the world. https://en.wikipedia.org/wiki/X-ray_fluorescence https://www.bruker.com/products/x-ray-diffraction-and-elemental-analysis/handheld-xrf/how-xrfworks.html http://www.metmuseum.org/about-the-museum/now-at-the-met/features/2010/behind-the-scenes-thedepartment-of-scientific-research https://www.facebook.com/metmuseum/photos/a.10152626481897635.1073741849.6296252634/101526 26482012635/ http://blogs.guggenheim.org/checklist/art-and-science-on-fifth-avenue-the-met-and-the-guggenheimcombine-forces/ https://www.royalarmouries.org/what-we-do/conservation/conservation-in-practice/xrf-analysis http://www.history.org/history/museums/conservation/analytical.cfm?showSite=mobile https://www.brooklynmuseum.org/community/blogosphere/2011/01/26/analyzing-pigments-in-the-book-ofthe-dead-using-xrf-spectroscopy/ https://www.fieldmuseum.org/science/special-projects/elemental-analysis-facility/portable-x-rayfluorescence-pxrf https://www.britishmuseum.org/about_us/departments/conservation_and_science/research/scientific_tech niques/x-ray_fluorescence.aspx http://www.getty.edu/museum/conservation/papers.html http://www.artcons.udel.edu/about/kress/examination-techniques-and-scientific-terms/x-ray-fluorescence https://ellencarrlee.wordpress.com/tag/museum-xrf/ http://airandspace.si.edu/explore-and-learn/multimedia/detail.cfm?id=10012 http://upers.kuleuven.be/en/book/9789058679079 http://www.ncbi.nlm.nih.gov/pubmed/17867530 https://www.uantwerpen.be/en/rg/axes/research/research-topics/in-situ-ma-xrf-scann/ http://www.sciencedirect.com/science/article/pii/S0168583X10000844 http://www.ncbi.nlm.nih.gov/pubmed/24004868 http://www.heritagesciencejournal.com/content/1/1/2 https://www.royalarmouries.org/what-we-do/research/analytical-projects/investigating-a-sixteenth-centurywelsh-buckler This technology is in use by nearly every major museum in the world. Happy Collecting! Kelly Hicks END