P.DG A4001N User Manual

Anuncio
P.DG A4001N
User Manual
Copyright © 2011 ADB Broadband S.p.A. All rights reserved. This document contains ADB proprietary and confidential information. No part of this document may be copied, reprinted or reproduced in any material form or electronically, whether wholly
or in part, and no information contained herein may be used or disclosed to third parties unless under a previous written agreement with ADB Broadband S.p.A setting forth relevant terms and conditions.
Trademarks:
All terms used in this document that are known to be trademarks or service marks have been noted as such. ADB cannot attest
to the accuracy of this information. Other product and corporate names used in this document that may be trademarks or service marks of other companies are used only for explanation and to the owner’s benefit, without intent to infringe. Use of a term
in this document should not be regarded as affecting the validity of any trademark or service mark.
This publication is subject to change without notice. ADB reserves the right to make changes to equipment design and system
components as well as system documentation and literature as progress in engineering, manufacturing methods, or other circumstances may warrant.
This publication is intended solely for informational and instructional purposes. Refer to the above as to its possible uses. It constitutes neither a contract with the user hereof nor a warranty or guarantee with regard to any of the ADB products described
herein nor shall it be construed to grant a license or any other rights under any proprietary rights to information or material included herein. ADB hereby expressly disclaims any warranty or guarantee, whether express or implied, with regard to items described herein. Any contract, license, or warranty between ADB and the user hereof is created solely by separate legal documents.
Home Station ADSL ADB P.DG A4001N
CONTENTS
Welcome 1 About this Guide 1 Naming Convention 1 Conventions 1 Procedures 3 How to change Access Password 3 How to open ports 4 How to Upgrade the Firmware 6 How to how to configure the ADSL line addessing >> static with RFC1483 7 How to how to configure the ADSL line addessing >> dinamic with PPPoE 12 How to configure the LAN access 17 © (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
i
Welcome
ABOUT THIS GUIDE
This guide describes the most relevant user procedures for the Home Station ADSL
ADB P.DG A4001N. This guide is intended for use by those responsible for supporting the installation and setup of network equipment; consequently, it assumes a
basic working knowledge of LANs (Local Area Networks) and Internet Routers.
NAMING CONVENTION
Throughout this guide, the P.DG A4001N
Category 5 Ethernet Cables are referred to as Ethernet Cables throughout this guide.
CONVENTIONS
Table 1 and Table 2 list conventions that are used throughout this guide.
Icon
Notice Icons
Notice Type
Description
Information note
Information that describes important features or instructions.
Caution
Information that alerts you to potential loss of data or potential damage to an application, system, or device.
Welcome
TABLE 1.
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Welcome
1
Home Station ADSL ADB P.DG A4001N
TABLE 1.
Icon
TABLE 2.
Notice Icons
Notice Type
Description
Warning
Information that alerts you to potential personal injury.
Text Conventions
Convention
Description
ething, and then press Return or Enter. Do not press Return or Enter
when an instruction simply says
Keyboard key names
If you must press two or more keys simultaneously, the key names
are linked with a plus sign (+). Example:
Press Ctrl+Alt+Del
Words in italics
Italics are used to:

Emphasize a point.

Denote a new term at the place where it is defined in the text.

Identify menu names, menu commands, and software button
Help menu, select Contents. Click
OK
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
2
Welcome
Procedures
This chapter is dedicated to the main how-to procedures description. For a more
complete device description and operative guidelines, please refer to the product
Administrator Manual.
HOW TO CHANGE ACCESS
PASSWORD
Please follow below procedure s

Open your web browser and connect to http://192.168.1.1/main.html


Select from the left menu the it
-


For the selected account, insert in the related input box the curre
Procedures

to confirm your changes.
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
3
Home Station ADSL ADB P.DG A4001N
FIGURE 1.
Access Password Change panel
HOW TO OPEN PORTS
Some applications require that specific ports in the Router's firewall be opened for
access by the remote parties. Port Trigger dynamically opens up the 'Open Ports' in
the firewall when an application on the LAN initiates a TCP/UDP connection to a remote party using the 'Triggering Ports'. The Router allows the remote party from
the WAN side to establish new connections back to the application on the LAN side
using the 'Open Ports'. A maximum 32 entries can be configured.
Please follow below steps to learn how to open ports in the firewall:

Open your web browser and connect to http://192.168.1.1/main.html


-

In the shown panel (see
port

A new panel (see Figure 3) will be shown: you can configure the port settings from this screen by selecting an existing application or creating your
own (Custom application)



In the table, insert the Trigger port range, Trigger protocol, Open port range
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
4
Procedures
Home Station ADSL ADB P.DG A4001N

FIGURE 2.
Port Triggering panel
FIGURE 3.
Port Triggering panel #2
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
5
Home Station ADSL ADB P.DG A4001N
HOW TO UPGRADE THE
FIRMWARE
Please follow below steps to learn how to update the device firmware:

Obtain an updated software image file from your ISP

Open your web browser and connect to http://192.168.1.1/main.html

Insert the a

-
p-

Enter the path to the image file location in the
box or click the "Browse" button to locate the image file

Click the "Update Software" button once to upload the new image file.
The update process takes about 2 minutes to complete, and your Router
will reboot.
FIGURE 4.
Firmware Upgrade panel
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
6
Procedures
Home Station ADSL ADB P.DG A4001N
HOW TO HOW TO
CONFIGURE THE ADSL LINE
ADDESSING >> STATIC WITH
RFC1483
To configure a static ADSL line addressing it is necessary to configure the ATM and
WAN interface according to below steps:

Open your web browser and connect to http://192.168.1.1/main.html



Please verify to have the following settings:
FIGURE 5.
o
VPI = 8
o
VCI = 35
o
DSL Latency = Path0 (Path1 deselected)
o
DSL Link type = IPoA
o
Encapsulation Mode = LLC/SNAP-ROUTING
o
Service Category = CBR
o
Peak Cell Rate = 452
o
Enable IP QoS NOT checked
ATM Interface Configuration
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
7
Home Station ADSL ADB P.DG A4001N

ly changes


-item
In the shown panel, please insert:
o
FIGURE 6.
Service Description = PVC: 8/35
WAN Service panel


In the WAN IP Settings panel (see Figure 7), please insert:
o
WAN IP Address = 172.26.208.12
o
WAN Subnet Mask = 255.255.240.0

FIGURE 7.
WAN IP Settings panel
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
8
Procedures
Home Station ADSL ADB P.DG A4001N

In the Network Address Translation Settings panel (see Figure 8), please insert:
o
Enable NAT NOT checked
o
Enable Firewall NOT checked
o
Enable IGMP Multicast checked

FIGURE 8.

Network Address Translation panel
In the Routing Default Gateway panel (see Figure 9), please check to have
the ipoa0

© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
9
Home Station ADSL ADB P.DG A4001N
FIGURE 9.

Routing Default Gateway panel
In the DNS Server Configuration panel (see Figure 10), please insert:
o
Select DNS Server Interface from available WAN Interfaces NOT
checked
o
Use the following static DNS IP Address checked with

Primary DNS Server = 80.58.61.250

Secondary DNS Server = 80.58.61.254

© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
10
Procedures
Home Station ADSL ADB P.DG A4001N
FIGURE 10.

DNS Server Configuration panel
In the WAN Setup Summary (see Figure 11), please verify that:
o
Connection type = IPoA
o
NAT = Disabled
o
Full Cone NAT = Disabled
o
Firewall = Disabled
o
IGP Multicast = Enabled
o
Quality of Service = Disabled

© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
11
Home Station ADSL ADB P.DG A4001N
FIGURE 11.
WAN Setup Summary panel
HOW TO HOW TO
CONFIGURE THE ADSL LINE
ADDESSING >> DINAMIC
WITH PPPOE
To configure a dynamic ADSL line with PPPoE addressing it is necessary to configure
the ATM and WAN interface according to below steps. Please consider that this procedure will allow you to configure two pvc: the second allowed pvc configuration in
below indicated between square brackets. Contact your ISP to know which one of
them is the proper one.

Open your web browser and connect to http://192.168.1.1/main.html


-
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
12
Procedures
Home Station ADSL ADB P.DG A4001N
FIGURE 12.

ATM Interface panel
Please verify to have the following settings:
o
VPI = 8
o
VCI = 35 [36]
o
DSL Latency = Path0 (Path1 deselected)
o
DSL Link type = EoA
o
Encapsulation Mode = LLC/SNAP-ROUTING
o
Service Category = UBR without PCR [UBR with PCR]
o
[Peak Cell Rate = 301]
o
Strict priority checked
o
Weighted Fair Queuing not checked
o
[Enable IP QoS checked]]


-item
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
13
Home Station ADSL ADB P.DG A4001N
FIGURE 13.

WAN Service panel
In the shown panel, please insert:
o
Select WAN Service type = PPP over Ethernet
o
Enter Service Description = PVC: 8/35 [PVC: 8/36]

Click on the Next button to proceed

In the shown PPP and password panel (see Figure 14), please insert:

o
PPP username = (given user name)
o
PPP password = (given password)
o
PPPoE Service name = empty
o
Authentication Method = AUTO
o
ALL remaining fields must be unchecked
Click on the Next button to proceed
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
14
Procedures
Home Station ADSL ADB P.DG A4001N
FIGURE 14.
PPP and password panel

In the Routing Default Gateway panel (see Figure 15), please verify to
have your pppo [ppp1] interface in the Selected Default Gateway Interfaces
box

Click on the Next button to proceed
FIGURE 15.
Routing Default Gateway panel
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
15
Home Station ADSL ADB P.DG A4001N


In the DNS Configuration panel (see Figure 16), please verify that:
o
Select DNS Server Interface form available WAN Interfaces is unchecked
o
Use the following Static DNS IP Address:

Primary DNS Server = 80.58.61.250

Secondary DNS Server = 80.58.61.254
Click on the Next button to proceed
FIGURE 16.
DNS Configuration panel
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
16
Procedures
Home Station ADSL ADB P.DG A4001N

In the WAN Setup Summary panel (see Figure 17) please verify that:
o
Connection type = PPPoE
o
NAT = Enabled
o
Full Cone NAT = Disabled
o
Firewall = Enabled
o
IGP Multicast = Disabled
o
Quality of Service = Disabled

FIGURE 17.
HOW TO CONFIGURE THE
LAN ACCESS
WAN Setup Summary panel
To configure LAN interface it is necessary to follow below steps:

Open your web browser and connect to http://192.168.1.1/main.html

© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
17
Home Station ADSL ADB P.DG A4001N

Sele
(see Figure 18)

Please verify to set the following fields:
-
o
IP Address = (router address: 192.168.1.1 by default)
o
Subnet mask = 255.255.255.0
o
Enable IGMP Snooping not checked
o
Enable LAN side firewall not checked
o
Enable DHCP server checked:
o

Start IP Address = first IP Address in the allowed IP range

End IP Address = last IP Address in the allowed IP range

Leased Time (hour) = 24

Static IP Lease list = MAC Address and IP Address till a
max of 32entries to be added/removed for a static IP as-
Configure the second IP Address and Subnet Mask for LAN interface:

IP Address = 192.168.249.1

Subnet Mask = 255.255.255.252

FIGURE 18.
LAN panel
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
18
Procedures
Home Station ADSL ADB P.DG A4001N
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Procedures
19
ADB Broadband S.p.A
Viale Sarca 222
20126 Milano
http://broadband.adbglobal.com
Descargar